Natural Resources Canada

The marks left in the seabed by the commercial anchoring process can be seen as linear features in high-resolution multibeam bathymetry data. These features have been digitized to polylines for individual marks and polygons for anchor scour zones for British Columbia's (BC) commercial anchorages....

The Canadian Gravity Anomaly Data Base consists of approximately 660 000 gravity observations, including 165 000 on land, acquired between 1944 and the present. The data spacing ranges from less than 1 km to over 20 km, with an average spacing between 5 and 10 km. All measurements were reduced to...

The Canadian Gravity Anomaly Data Base consists of approximately 660 000 gravity observations, including 165 000 on land, acquired between 1944 and the present. The data spacing ranges from less than 1 km to over 20 km, with an average spacing between 5 and 10 km. All measurements were reduced to...

The Canadian Gravity Anomaly Data Base consists of approximately 660 000 gravity observations, including 165 000 on land, acquired between 1944 and the present. The data spacing ranges from less than 1 km to over 20 km, with an average spacing between 5 and 10 km. All measurements were reduced to...

The Canadian Gravity Anomaly Data Base consists of approximately 660 000 gravity observations, including 165 000 on land, acquired between 1944 and the present. The data spacing ranges from less than 1 km to over 20 km, with an average spacing between 5 and 10 km. All measurements were reduced to...

The Canadian Gravity Anomaly Data Base consists of approximately 660 000 gravity observations, including 165 000 on land, acquired between 1944 and the present. The data spacing ranges from less than 1 km to over 20 km, with an average spacing between 5 and 10 km. All measurements were reduced to...

The Canadian Gravity Anomaly Data Base consists of approximately 660 000 gravity observations, including 165 000 on land, acquired between 1944 and the present. The data spacing ranges from less than 1 km to over 20 km, with an average spacing between 5 and 10 km. All measurements were reduced to...

In the hydrogeological unit, quantity of water that replenishes groundwater beneath the water table, expressed in mm/yr. Recharge is usually calculated using hydrology balance, integrating information from precipitation, hydrology data, drainage, soil properties, evapotranspiration, etc. The...

Level below which soil or rock is saturated with water, in the well and at the time the level has been measured, expressed in m above the sea level. Groundwater depth is measured on the field, using a water level meters. The depth is then subtracted from the elevation of the measurement site to...

Groundwater flow is the movement of water in an aquifer or hydrogeological unit. The dataset shows groundwater flow rate and direction in the hydrogeological unit. Groundwater flow is establish from piezometric surface map. The method used to create the dataset is described in the metadata...

The amount of groundwater exploited is estimated in m³/year. Groundwater usages are classified in four categories: agricultural, industrial, domestic and energy. Typically, groundwater usage should be represented as a series of sub-polygons or points fitting inside the boundary of the...

Hydraulic properties characterize a hydrogeological unit. The hydraulic properties considered for this dataset are the transmissivity, the hydraulic conductivity, the storage coefficient, the specific storage coefficient and the porosity. Hydraulic properties are estimated by performing aquifer...

The confinement describes the types of aquifer: confined, unconfined and semi-confined. Confined aquifer is bounded from above and below by impervious formations. Unconfined aquifer has a water table which serves as its upper boundary. Semi-confined aquifer is in between. Aquifer confinement is...

A measure of the intrinsic susceptibility of an aquifer representing the tendency or likelihood for contaminants to reach a specified position in the groundwater system after introduction at some location above the uppermost aquifer. The method used to create the dataset is described in the...

Surficial geologic units are unconsolidated materials overlying bedrock. The dataset represents a general description of the stratigraphy and geology, including geologic unit thickness, morphology, age and rank. It features a list of the geologic unit names and types of sediment in the...